Want this question answered?
If the load is connected to the motor via belts, you can change the speed the load is turning by changing the pulley sizes. To get the load to slow down, increase the size of the pulley on the load; to get it to speed up, increase the size of the pulley on the motor. To reduce the speed of the motor itself, you'll have to alter the line frequency, which you can't do without a variable frequency drive attached to the motor.
calculate speed drive pulley.
Securely chock front wheels. Jack up rear. Securely support on axle stands or blocks under rear wheels. Unbolt towing eye to access nut beneath which secures variable speed pulley. Unbolt and remove variable speed pulley. Unbolt and remove idler wheel next to variable speed pulley. Now, slightly more difficult, remove double pulley ( upper drive and lower cutter belt ) from engine drive shaft. Long reach 17/16 ? Socket necesary from engine shaft. Prevent. engine turning (DISCONNECT SPARK PLUG just in case) using bar through hole in lower (cutter) pulley - may need to tap down on lower pulley ( carefully - don't damage pulley ) to release pulley shaft from engine shaft ( this is keyed ). Locate new belt and re-assemble engine pulley. Route both belts and continue to reverse assembly.
A Body has variable speed if it covers unequal distance in equal interval of time is known as Variable Speed
Both speed and acceleration can be variable, depending on the circumstances.
The difference is that constant speed doesn't change but variable speed does. (change)
It is not necessarily a motion in itself... Variable speed refers to something that can change speeds, or that the speeds can be changed. There are many things that can be variable speed.
It sounds like you need a variable speed drill. There was an item on the market a few years ago that you could plug your drill into and control its speed. I haven't seen one lately since most new drills have variable speed built into the drill. On a drill press all you need to do is move the drive belt to the smallest pulley on the motor and the biggest pulley on the drill spindle.
No, it is a continuous variable.
Dependent variable is usually speed.
both lift same speed both lift same speed
Yes, the internal variable for an object's speed in Game Maker is <Object_Name>.speed.