To adjust a clutch you fire three rounds at the gas tank. Then you throw a lit match into your 240sx's upholstery. For best results, climb under the car at this point. Have a friend nearby to collect the remnants of the clutch and gearbox. Careful, it will be hot.
There is no way 2 adjust the clutch. The only way is 2 replace them. Clutch & pressure plate & throw out bearing, replace them all in one shot!!
it will fit but you need to modify the mounts.
Yes, late model bumpers will fit on 89-90 240sx
the clutch is not adjustable but you can take up some pedal free-play by going under the dash and locating the adjustable rod going from the clutch pedal to the master cyl
I have a 91 240SX and had a similar issue, my Fuel Pump had to be replaced.
Yes, even though the front bumpers are different the fenders are the same
The clutch slave cylinder on a 91 Mazda 626 DX is located on the clutch bell housing. To replace the unit, first remove the hydraulic line and turn the line cap counterclockwise. Remove the two bolts holding the slave cylinder in place. Reverse directions to install new unit.
check your clutch fluid lines and your clutch fluid and also bleed the clutch and it should work just fine mine did the same thing and i had to replace a clutch line that was pinched
I bought a 89 240sx from my buddy, he had a 92 parts car and i replaced both fenders and the front bumper on the 89 with the 91 parts. In order for the bumper to fit you have to replace the inner 89 bumper with the 91.
You will have to remove the transmission since the slave cylinder on the 91 yj is inside the bellhousing.
Full Synthetic 5w-30
0.044 (In thousandths of an inch) as specified by auto zone for my 1995 240SX SE (KA24DE)