You dont say adjust in what direction, pull the car up facing a wall/door stop about 20 feet away turn lights on and watch where the light goes that will tell ya whats going on
There are little gears right behind the headlight assemblies.
I have not yet found a way to adjust left and right, but to adjust up and down, there is a small grey adjustment bolt. It is located on the back of each headlight housing and can be adjusted using an 8mm socket. Look for a hex bolt that appears to have a notched disc attached to it. Note to those who don't know: headlights should always be aimed slightly downward, with the drivers side aimed a little lower than the right.
You don[t adjust it. If it isn't tracking right something is bent or broken.
"Bolo" is an acronym for "Be On the Look Out". For example, if a blue Honda Civic with a broken right headlight was used in the commission of a crime, the police might issue a "bolo" for it, which means all units would be looking out for a blue Honda Civic with a broken right headlight.
there are two screws on each side of car above each headlight the outer screws adjust the up or down of the headlight the screw that's in the middle adjust side to side motion of the headlight there is an level when they are set right the bubble should be centered
Actually if you look at the back of the headlight you will see an arangement of platic gears ... by turning those gears you can ajust the light possition. How exactly you might go about setting it right is up to you. Cheers, JFL
On a left hand drive vehicles, it is on the front right side behind the right headlight
from the headlight it self, there is small adjusting bolt which you will have to move it right or left as you want to adjust it (UP-Down). Fouad
pop the hood there should be 10 or 12mm bolts on top of each headlight assembly, this is right as you open the hood you cant miss them.
right front below headlight housing,,,drivers side!!
Open the hood there is a screw on top of the headlight assembly.Just turn the screw to adjust the headlight.
To adjust the headlight assembly on a 2002 Montana Van you will need to loosen the side adjuster screws located to the left and right of the headlight. With the lights on use a garage door or solid foundation to see if the lights are level. Once you have the headlight in a desired position tighten the adjuster screws to secure the light in place.