(1) Verify headlamp dimmer switch and high beam indicator operation. (2) Inspect and correct damaged or defective components that could interfere with proper headlamp alignment. (3) Verify proper tire inflation. (4) Clean headlamp lenses. (5) Verify that luggage area is not heavily loaded. (6) Fuel tank should be FULL. Add 2.94 kg (6.5 lbs.) of weight over the fuel tank for each estimated gallon of missing fuel. ALIGNMENT SCREEN PREPARATION (1) Position vehicle on a level surface perpendicular to a flat wall 7.62 meters (25 ft.) away from front of headlamp lens (Fig. 1). (2) If necessary, tape a line on the floor 7.62 meters (25 ft.) away from and parallel to the wall. (3) From the floor up 1.27 meters (5 ft.), tape a line on the wall at the centre line of the vehicle. Sight along the centre line of the vehicle (from rear of vehicle forward) to verify accuracy of the line placement. (4) Rock vehicle side-to-side three times to allow suspension to stabilize. (5) Jounce front suspension three times by pushing downward on front bumper and releasing. (6) Measure the distance from the centre of headlamp lens to the floor. Transfer measurement to the alignment screen (with tape). Use this line for up/down adjustment reference. (7) Measure distance from the centre line of the vehicle to the centre of each headlamp being aligned. Transfer measurements to screen (with tape) to each side of vehicle centre line. Use these lines for left/ right adjustment reference. HEADLAMP ADJUSTMENT A properly aimed low beam headlamp will project the centre of the low beam hot spot on the alignment screen from 178 mm (7 in.) below the headlamp centre line. The side- to-side left edge of low beam hot spot should be 127 mm (5 in.) to the right of headlamp centre line. The high beams on a vehicle with aero headlamps cannot be aligned. The high beam pattern should be correct when the low beams are aligned properly. To adjust headlamp alignment, rotate alignment screws to achieve the specified low beam hot spot pattern. confused tell me about it, but once you do it physically it will all come together
Shines Chan goes by Shines.
Johnny Shines's birth name is John Ned Shines.
Razor Shines's birth name is Anthony Razor Shines.
Shines is the correct spelling.
what activities you can do when the sun shines
Marcia Shines was created in 1975.
Shines Chan is 168 cm.
Loneliness Shines was created in 2005.
Yes. The sun loses energy as it shines. That is because it shines by turning hydrogen into helium.
sheezyart version: all 64 shines newgrounds version: 58 shines
The duration of Monkey Shines is 1.88 hours.
Razor Shines goes by Ray.