The plate with the lever in it is held on with 2 bolts. Take the bolts out and the plate will pull up and out. The stopper is on the end of a small rod. It will either screw up or down or will have a series of holes to adjust the stopper.
it is stopper =]
Styptic pencil is a bleeding stopper.
The Crystal Stopper was created in 1912.
Janina Stopper is 157 cm.
A CORK stopper is a plug for a bottle made of cork
The past tense of stopper is stopped.
If there is debris on the stopper it might be preventing a good seal. Try removing the rubber stopper and wipe it off to remove any debris that might be on it. Clean out the hole that the stopper goes into as well. This will help ensure a clean seal between the hole and the stopper. Put the stopper back into the hole, making sure it is a tight fit. If it still leaks you may need to buy a new stopper.
On most push/pull stoppers the knob part that you pull on unscrews from the stopper, and under that is a slot for a screwdriver tighten or remove the stopper. On stoppers with non-removable knobs, there is a screw (usually phillips) under the stopper which can be accessed with the stopper in the up position and unscrewed to remove the stopper.
At the back of the mirror you will find a rubber stopper. The stopper is same color as the mirror. Remove that stopper and it will reveal a screw. Tighten the screw to adjust. Be careful not to remove the screw. If you do you will have to open up the mirror to catch it back. Also, depending on how flexible you are and the length of your screwdriver, you may need to remove the mirror. Use a screwdriver to pry out the plastic cover and and you will see all three screws holding the mirror to the roof.
Juan Stopper Sanchez was born in 1941.
Juan Stopper Sanchez died in 1991.
Show Stopper was created on 2006-08-22.