There are 2 knobs on each headlight
The knob that is higher than the other one which is also pretty much behind you low beam globe adjusts the up and down of the headlight reflector. The other knob behind the high beam must do left and right
Same applies for the passenger side, but is reversed, turning the knob away from the engine will make the reflector go up and turning the knob towards the engine will make it go down. The easiest way to tell is if there is alot of thread showing on the knob then the reflector is pointing up wards. If there isnt much thread showing on the knob then the reflector is pointing down.
The headlight have adjustment levelers on the top and bottom of each headlight. Adjust the headlight up or down with the adjustment levelers.
OPen the hood, by the headlight there is a knob you can turn either up or down.
there are two screws on each side of car above each headlight the outer screws adjust the up or down of the headlight the screw that's in the middle adjust side to side motion of the headlight there is an level when they are set right the bubble should be centered
from the headlight it self, there is small adjusting bolt which you will have to move it right or left as you want to adjust it (UP-Down). Fouad
Replace the slow headlight motor.
There should be a screw just over the top of the headlight (you're going to have to get down on your hands and knees to see it). Screw it IN (clockwise) to adjust the aim higher. Park about ten ft. away from a building, on level ground. Measure from the ground to the center of the headlight. Now make a mark on the building at that height in front of the headlight. Adjust the headlight so it centers on that mark.
There are two screws on the back of each headlight housing. One adjusts up and down, the other side to side.
open hood. On top of each headlight there is an adjustment screw. Turn it either way to lower/raise the headlight
Open the hood there is a screw on top of the headlight assembly.Just turn the screw to adjust the headlight.
There is a bolt with a torx bit head on it behind the headlight if i remember right there should be two of them one is for up and down the other is for in and out.
I can't speak for earlier models but on my '07 you have to take off the metal cap on the "eyebrow" to access the mounting bolt. Loosen that nut and the headlight is now free to move left to right and up and down. Adjust, and re-tighten the nut.
Remove the fender well 8mm bolts and the up/down adjust bolts are on the side of the headlight. You must remove the fender well