Through the carburetor or advance or retard the distributor by turning the distributor cap barely left or right. If you cant turn it then loosen the bolt holding the distributor on to the intake with a wrench then turn the distributor til the engine sounds like its not missing or not to where it's about to turn off.
The idle speed is computer controlled. There is no adjustment. If the speed is too high or low, there is a sensor/actuator/wiring issue.
under the plastic in the middle
There is no idle adjustment screw as the idle speed is controlled by the computer. Excessivly high idle is most likely caused by and intake manifold leak, or a bad idle air control valve.
Idle is computer controlled, no adjustment screw.Idle is computer controlled, no adjustment screw.
There is no adjustment screw, idle is automatically controlled by the pcm.
1500 at first until it kicks down to 850 rpm
choke idle adjustment on 1988 Buick Riviera
You can adjust the idle speed on your 1992 Honda 250, motorcycle with the fuel pump adjustment screw. Turning the adjustment screw will adjust the flow of fuel.
The idle adjustment screw is located on the IACV behind the manifold on a 1998 Honda CR-V. Open the latch on the IACV then take an screwdriver and tighten the adjustment screw.
there is no idle adjustment on the neons it controlled by the computer wich opens and closes the idle air control motor located on or near the intake
The IDLE is controlled by the computer. THERE IS NO ADJUSTMENT.
You can adjust the idle air control valve on a 1992 1500 truck while it is just idling. This is done if the truck is idling too fast or too slow. It will help the truck run better.