remove the brake line from the caliper. press the brake pedal a few times until you notice all the brake fluid in the brake fluid container under the hood is completely drained. put the line/hose back on the caliper. pour brake fluid into the container to required. remove the line/hose once more to remove any air that may have stayed in the tubing. place the line back on once more after you notice the fluid pouring out. (don't let all the new fluid drain out). fill container once more to required. make sure your brake pedal is not too spongey when you press it. this can be a dirty job so don't forget to bring a towel.
They are self bleeding.
Oil Filter 2003 Alero V6 3.4L part no. 3387
i have a 2003 olds alero i need to know the location of the camshaft sensor
they can bleed if they get to wet or hot or if it breaks and if u press to hard did that answer it
Dogs bleed the same way people bleed. When they have a cut or any other injury that breaks the skin they will bleed.
By the caliper on top is like a 9 mm
how do i bleed brakes on a 2003 hyunia xg350
When playing with the electrical system to a car, it is important to have a diagram. A diagram for a 2003 Alero can be found in online forums and in maintenance books.
It does not have a distributor cap.
The thermostat is located on a 2003 Oldsmobile Alero in the thermostat housing. The thermostat housing is located on the rear side of the engine block.
Bleed the Dream was created in 2003.
To change the antifreeze on a 2003 Alero once the car cools remove that radiator pressure cap. Pour in a gallon of pre mixed coolant.