How do you clutch bleed?
One person in the cab to work the clutch pedal.
One person underneath the car, rt side of transmission, with small hose on bleed nipple - other end into brake fluid bottle, and box wrench on the nipple.
Ck reservoir for fluid. Don't do more than 4 cycles without refilling the reservoir. Go more -- you're pumping air...
Can't get the nipple open? Unbolt the whole thing - called a the slave cylinder - and replace it. They are 20$ at Advance or Autozone...
Procedure:
Person in cab presses on clutch pedal to floor. Open bleed nipple and allow any fluid that comes out to flow into the open brake fluid container.
Tighten bleed nipple, tell person in cab to release pedal.
Repeat process until only fluid comes out on each pedal press with no air bubbles...
Pedal should now have pressure and work the clutch correctly...
10 gal i have a 1977 datsun 280z 2+2 and at $3.21 a gal it takes 40 from empty
Yes, the 1978 Datsun 280Z has seat belts.
i do not know but you cna ask some other people m8
Front are 4" Rear Seat Side Panels are 6x9"
I own a 1977 280Z automatic and the fuel pump relay is located above the kick panel on the right passenger's side floor in front of the door. You have to access it from under the dash.
1975
no
Check your dimmer switch under the dash first.
in the back under the carpet and rubber/foam mat. it should have straps holding it down
A Datsun 280Z
yes
yes but it's not cost effective and not a that much of a noticeable difference in performance