Want this question answered?
On the opposite side of the trans from where the clutch line enters, a fitting with a bleed valve on the end. You can get a great view if you remove the access panel around the shifter, you will be able to see them both from there, loosen the end to bleed.
I HAD THE SAME PROBLEM WITH MY 92 WRANGLER.. GO TO AUTOZONE.COM AND CLICK ON SERVICE MANUALS, THEY WILL EXPLAIN HOW TO BLEED THE SLAVE CYLINDER.. AND IT WORKS.. DON DRC@EPIX.NET
how do you bleed a cluch on a 92 Saturn sl
There is not any adjustment on this clutch. Al you have to do is bleed the system.
on the drivers side underneath of your jeep u will find a hose with a bleed fitting on the end by by pushing in the clutch build pressure and have a friend loosen the bleed valve to release pressure until u do not get air out when first opening the valve be sure to keep the reservior full during this process and top off after finishing if this doesnt work u most likely have a bad slave cylinder. Where is the clutch bleed valve located
pray like hell
show me pictures
FOR ME THERE IS NO WAY TO BLEED A CLUTCH ON A SATURN BUT IF YOU REPALCE ONE PART SOMETIME ITS POSSIBLE. 20 % CHANCE .THE ONLY WAY ITS TO REPLACE THE SLAVE AND THE CYLINDER AS A SEALED KIT
at the slave cylinder, you will need to remove the clutch inspection plate to do so.
Yes
On the bottom right there is a slave cyl you take a ten mm wrench have someone pump the clutch hold it open the bleeder they will fill the pedal go down then tighten it repeat several times
Yes.