answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2007-09-04 18:32:03
2007-09-04 18:32:03

Start at the longest (R-R) and work toward the shortest (L-F) ATTACH A PIECE OF FLEXIBLE TUBING TO THE BLEEDER SCREW AT THE TOP OF THE WHEEL CYLINDER OR CALIPER INSERT OTHER END INTO A CONTAINER FILLED WITH CLEAN BRAKE FLUID

HAVE ASSISTANT PUSH BRAKE PEDAL DOWN APPROX. 2/3 OF FULL TRAVEL OPEN BLEEDER SCREW AND OBSERVE BUBBLE IN CONTAINER OF FLUID

CLOSE BLEEDER SCREW REPEAT PROCESS UNTIL NO BUBBLES ARE OBSERVED AND GO TO NEXT WHEEL MAKE SURE MASTER CYLINDER REMAINS FULL AT ALL TIMES

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


You replace the brakes on an ABS S10 the same way you replace brakes on a non ABS S10.


Yes, the front has discs brakes on them.


My 1989 chevy s10 doesn't accelerate quckly,why is this?


what does a 1989 Chevy s10 Tahoe 6 cylinder get in gas mileage


Probably air in the system.





bleed it the same way u would bleed the brakes the bleeder is on the driver side of the trans on the bell housing



Need to know what engine it has.




Cycle the ignition switch a few times from off to on, it will bleed itself.


Between 4500 and 4800 pounds.


There is no adjustment to my knowledge.


If you have an owners manual, it will tell you in that.


The same way you would for brakes. Pump the clutch 4 or 5 time and hold down then open the bleeder valve to release the air. Is it the 2.8L V6 motor?



The cost of the brake parts for the 1998 Chevy S10 truck range from 140.00 to 180.00. The cost of labor ranges from 45.00 to 65.00 an hour.


Any 1983 - 1993 S10, and 1983 - 1994 Blazer, Jimmy, or Bravada.


Brakes are shot or a wheel bearing is bad.


The 89 model does not have a VSS.


Yes, two, there are located in the throttle body.




Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.