0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the speed sensor on a 1995 Mitsubishi 3000 gt located?
On top of the transmission, near the clutch slave cylinder.
Wiring diagram for 1993 Mitsubishi 3000 gt?
http://www.3sx.com/faq/manuals/
How do you adjust the clutch on a 1993 3000 gt?
on some of the 3000 gt's there is a booster for the clutch pedal under the dash. In some cases this unit is not working and is a dealer item only. If you don't have one of these the way to bleed the slave cylinder is to just bleed it like you would the brakes. The slave cylinder is located on top of the transmission by the firewall and rear mount. for additional adjustment some have an adjustment at the pedal itself. I'm a mistu dealer tech and have done these many times.
If you change the stock clutch to a stage 3 clutch on a Mitsubishi 3000 gt what can you do if the car won't go into first gear?
its your tranny, you probably damaged the teeth on 1st gear or your syncros went out, if all gears are not going in then its your clutch
What causes a 1993 Mitsubishi 3000 gt sl transmission failure?
Overheating?Low oil Level?Worn out?
What causes vibrations while coasting in 1st gear on a 1993 Mitsubishi 3000gt VR4?
Bad struts can cause vibrations while coasting in first gear on a 1993 Mitsubishi 3000 GT VR4. A bad tire can also cause this.
Your 1999 Mitsubishi 3000 GT shut down on you as you were driving The Clutch pedal went to the floor the reservoir is dry how do you fill it and do you need to bleed the system if so how do you?
First, find out why the reservoir is empty. If you've developed a leak, you need to find out where it is and fix it. You might be able to get by just with a little fluid in the reservoir, but it will be far less headache in the future if you just fix the problem. Check for leaks in the clutch release cylinder. A new one costs about $60. You will need to bleed the system after adding fluid. Attach clear tubing (5/16" inside diameter, about 1 ~ 2 feet long) to the bleeder nipple on the release cylinder and run it to a container, loosen the nipple, have someone depress the clutch pedal and hold it down. Tighten the bleed nipple before the clutch pedal is released. Repeat until fluid runs out with no bubbles.
What does 3000 gt means?
3000gt is a Mitsubishi car.
Where is the inertia switch on a Mitsubishi 3000 GT?
in the trunk
How do you change an alternator ground wire on a 1994 Mitsubishi 3000 GT?
Refer to your service and user manual on how to change an alternator ground wire on a 1994 Mitsubishi 3000 GT.
Change alternator Mitsubishi shogun 2.5 d?
how to change an alternator Mitsubishi shogun 3000 v6
How do you install a rear crankshaft seal on a Mitsubishi 3000 GT?
Hi, Not an easy question to answer or an easy job to do. You will require a service manual to do this. It will require removing the transmission,clutch and oil pan if it is a rear seal. Good luck
