The rear brakes only have one bleeder screw, this is located on the drivers side above where the rear brake line threads into the wheel cylinder. A 10MM flare nut wrench will fit it. Loosen this screw and have someone slowly press the brake pedal and hold it down, then tighten the screw and repeat this process until all air bubbles are out of the system. It is easier if the vehicle is running while you do this so be sure to chock the wheels for safety purposes.
I have a 2002 Chevy tracker and it gets anywhere from 28 to 25 miles to the gallon.
how many mounting bolts hold 2002 chevy tracker starter in place
Just like any other vehicle. Google, "Bleeding Brakes" for complete instructions. Just remember to bleed RR, LR, RF, LF in that order, and never let the master cylinder run dry.
with tools.
how to remove back brakes on a 2002 Chevy surban
my 2002 never has ...I know there is a "height sensor-proportioning valve" located above the rear axle which should prevent the rear brakes from locking... when you brake the weight of your Tracker goes forward and the rear actually lifts... this device lessens the pressure to the rear brakes momentarily so they don't lock...
no
R-134a
with a rev counter
The alternator is failing.
The fuse box of a 2002 Chevy Tracker is located under the dash, near the hood release. It contains many important fuses which protect the vehicle's electrical systems.
I have a 2002 Tracker with a 4-cylinder engine. The manual says it can tow 1000 pounds. The 2002 6-cylinder model can tow 1500 lbs per the owners manual; however, brakes are needed on the trailer for anything over 1000 lbs.