Heater Cores and Blower Fans

How do you bypass a heater core in a 2001 Dodge pickup?

131415

Top Answer
User Avatar
Wiki User
Answered
2005-11-13 14:38:52
2005-11-13 14:38:52

To bypass the heater core you need to remove the two water hoses going through the firewall from the engine compartment to the heater core and connect them together so that the water loops around back to the engine.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Blower motor resistor assembly is located under dash board on passenger side.

It will bolt up, but the internal sensors are wired differently. So it will not shift.

In the middle of the heater box under the dash.

Simple, take the inlet and outlet hoses going to and from the heater core and connect them together.

can you by pass a safety neutral switch on a 2001 dodge neon

You cannot fix the heater core but instead you must replace it and this will be a complete dash pull along with discharging and recharging the a/c system.....its a very long and complicated job................

where is the PCM or power control module, on a 2001 dodge ram p/u.

If you are asking about the blower you only have one that controls both the heater and the a/c............

2001 dodge ram 1500 ac and heater flow regulator switch does not work. works only on defrost. How to fix?

You should probably bring it to a mechanic because it is very difficult to replace the heater core on GMC pickups.

In the middle of the heater box under the dashIn the middle of the heater box under the dash

AN engine that will not run correctly if at all.

Haynes repair manual, Dodge Neon 2000 thru 2003. Book #30036

The radiator drain plug on a 2001 Dodge Ram 3500 pickup truck with a 5.9 liter diesel engine is on the bottom inside corner of the radiator. It is on the driver's side.

The servo is under the battery. The engine computer controlls it.

Idle is automatically set by the computer with the use of an idle motor.

Dodge does not use inertia/reset switches.Dodge does not use inertia/reset switches.

You have to remove the dash and HVAC housing.

it will only work if you take apart the hub caps, engine, quadreceps and antibypeds


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.