Oldsmobile Alero

How do you bypass the ignition security switch in a 2002 Oldsmobile alero?

234

Top Answer
User Avatar
Wiki User
Answered
2011-09-12 23:44:15
2011-09-12 23:44:15

Yes to bypass,Press on the brake, turn car to as then on let the carburetor fill then, put the car in neutral,then start. If the security light is flashing, the car will not start for 10 minutes. Do not try to start while light is flashing.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions




Can anyone please tell me where the ignition switch is located on a 2000 oldsmobile silhouette?


How do remove and replace the ignition switch of a 1983 Oldsmobile Regency?


how do you fix security switch on a 2002 oldsmobile alero


To bypass the ignition switch on a 1994 Chevy Astro, simply attach a wire to the ignition switch where it makes contact after the key is turned on. Run the wire to the push button and install at the lower part of the ignition switch to send power to the starter. Ê



Remove the retaining ring from the top of the ignition switch. Pull the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.


The ignition switch is located inside the steering coulum below the key and tumbler.


lost key for atv need to know how to install ignition


Yes, you can. However I would not recommend it.


where is the brake light switch for 1996 Oldsmobile cutlas supreme


The only Killswitch is the ignition switch. GM vehicles are not equipped with a fuel pump inertia switch.


It doesn't have one, it has a switch on the clutch pedal. It also has an interlock switch on the dash, turn the ignition switch on and press the interlock switch and it will bypass the clutch switch.


i need a wiring diagram with pictures to help put my ignition switch back together on my 99 olds intrigue




Did you activate the anti-theft system when you changed the ignition switch? If it has been activated you will need to have it reprogrammed at the dealer. good luck!


Are you using an original key, or a replacement that has the proper security computer chip located in the fat plastic part of the key? If not, the car's security system will keep the ignition locked and will not allow you to turn the ignition switch. ALSO: some earlier models of Focus had ignition switches that were a problem. If you ARE using the correct key and can't turn the switch to start the car anymore, the ignition switch may have to be replaced.


Get a repair manual for your truck, because you will need to cut the wires out of the ignition switch, and bypass the alarm.



Why is the charger controller on a 49cc change from a four wire to a three wire?


2002 mazda ,,gauges are still working after taking out key..any ideas


Disabling the keyless ignition security lock on a 2007 Saturn can be done by programming the security locks. Turn the ignition to run, without actually starting the engine, and press the unlock switch for eight seconds.


There is no kill switch. It's passlock, a passive security system that works with your radio, ignition, and dashboard. There is a procedure to bypass passlock, but it's complicated. To get your car started, just leave the ignition on for 10 minuites and the security light will go out, and you can start your car. If you've recently changed a radio, dashboard, or installed a remote starter, you probably affected passlock.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.