no
Same as you would in inches 3.14159265 and PSI have to be known
1
100 kw is the power drawn by the load. to calculate the cable size you need to know the voltage. From that you can calculate the current. this decides the cable size. for example if the voltage is 400Volts then the current flowing in the circuit when the load is 100 KW will be 250 amps. (100,000/400). for 250 amps to flow with out causing excessive heating of the cable the cross sectional area of the copper cable should be 150 sq mm.for a round cross section the diameter will be roughly 15mm.
The free electrons flowing in the circuit decrease.
Ohm's Law requires you know two of three parameters to calculate the third. Volts = Amps x Ohms You need to know current flowing through resistance to calculate voltage drop.
You'll need the length of the pipe, because that's where the flow resistance is. At the outlet end, the pressure is atmospheric.
When a steadily flowing gas flows from a larger diameter pipe to a smaller diameter pipe the speed of gas is decreased and pressure become increased and the spacing between the streamlines less and the streamlines come very close to each other.
Same as you would in inches 3.14159265 and PSI have to be known
Abdolhosein Mohandes has written: 'Friction losses for water flowing in non-circular ducts' -- subject(s): Hydrodynamics
The formula you are looking for is I = W/E. Amps = Watts/Volts.
No If the hole is smaller then the diameter of the supply line
Blood coming out of the capillaries passes into vessels of increasing diameter as it flows back toward the heart. It is usually deoxygenated.
1
The speed of the gas must increase. Also, depending on the geometry of the transition, it's comparatively difficult to maintain laminar flow, and there's typically considerable turbulence there and for some distance after.
ZERO as there is NO pressure given
I dont know. Stop asking stupid questions i need to do something for school in which i need the answer to this question. Go ask your parents, then tell me. Get a life.
Ohm's Law requires you know two of three parameters to calculate the third.Volts = Amps x OhmsYou need to know current flowing through resistance to calculate voltage drop.Read more: What_will_be_the_voltage_drop_across_each_of_the_following_resistors_A_160_Ohms_B_100_Ohms_C_82_Ohms_D_120_Ohms.