tons, a plural but one ton of rocks
24.7675 ton 1 US (short) ton = 2000 lb 1 UK (long) ton = 2240 lb 1 tonne (metric) = 2204.6 lb
I'm not an air conditioning expert, but I would expect that the compressor will run a lot more than it needs to. A 2 ton coil will not cool as much air as a larger capacity 3 ton coil. Experts?
how do you calculate the rate of osmosis
4,000 Lbs 2,000 LBS/ ton
188 nos.of rebar
80% 3,425 lb
269 6M lenths
You need the size of the rebar involved to calculate the weight. Charts can be found at CRSI.org or Rebarapps.com. Than take that and multiply it by the the length of the rebar. For example, a #4 rebar weighs 0.668 lbs/ft. If you have 5 @ 20-00 pieces that is 0.668 X 20 X 5 = 67 lbs. You need to know the size of the bar to calculate.
16mm weighs 1.552 kg/m 1 metric tonne 1000 kg So about 644m length
Cost vary according to the size and complexity of the job.DETAILINGA high of $30+ per ton USD for smaller jobs (100 tons+/-) with smaller rebar (#3,#4,#5), and a low of $15 per ton for larger jobs (1000+ tons) with larger bars (#11).ESTIMATINGFrom $5 to as low as $1 per ton again depending on the size and complexity of the project.
Rebar Detailing is a procedure of making shop drawings for the steel reinforcement for the development procedure. The Rebar Detailing procedure incorporates the position, bending shapes, amount, description, laps of the reinforcing steel and measurements. The Rebar Detailing Drawings are made to incorporate the separating, area, rebar size and lap of steel. The Rebar Detailing Services includes: Rebar Detailing Services, Rebar Shop Drawings Services, Rebar fabrication Services, Rebar Framing Plan Design, Rebar Structure Foundation, Rebar Pit Design, Rebar Framing Plan, Rebar Beam Design, Rebar Structure Steel Detailing, Structure Foundation Rebar Detailing.
To estimate the amount of rebar, a set of structural drawings are required. Once you have this information you will review the plans locating the sizes, spacings, configurations and locations of the rebar required. Each of these are reviewed in conjunction with the overall scope of the project. Using a means of tabulation, either via computer or paper, you roughly calculate and list each item. Then the tabulation can be utilized to calculate the weight and totals of the material to be used.
You have to find a chart that will indicate the weight per unit of measure for the appropriate rebar size. Than take that and multiply it by the the length of the rebar. For example, a #4 rebar weighs 0.668 lbs/ft. If you have 5 @ 20-00 pieces that is 0.668 X 20 X 5 = 67 lbs. Charts are available throughout the web or at CRSI.org.
it would depend entirely on the rebar design.....
Rebar Detailing is a procedure of making shop drawings for the steel reinforcement for the development procedure. The Rebar Detailing procedure incorporates the position, bending shapes, amount, description, laps of the reinforcing steel and measurements. The Rebar Detailing Drawings are made to incorporate the separating, area, rebar size and lap of steel. The Rebar Detailing Services includes: Rebar Detailing Services, Rebar Shop Drawings Services, Rebar fabrication Services, Rebar Framing Plan Design, Rebar Structure Foundation, Rebar Pit Design, Rebar Framing Plan, Rebar Beam Design, Rebar Structure Steel Detailing, Structure Foundation Rebar Detailing.
0