By the volt metre.
transformer max earth fault current
To calculate the no load current from transformer & core loss is also calculated.
The product of the secondary rated current and the secondary rated voltage will give you the rated V.A of the transformer.
The primary current on a loaded transformer depends on the secondary current, which is determined by the load. So, if you know the secondary load current, then you can use the turns ratio of the transformer to determine the primary current:Ip/Is = Ns/Np
Tis question is incompleet.1000 va =1 kva.This is the power capacity of transformer. A transformer having 2 currents Primary current and secondary current . for that we required both voltage. Simply we can calculate by a formula Voltage x Current x 0.8(power factor)=1000.
Without a load the secondary current is zero, by definition.
The secondary current is determined by the load. So, divide the secondary voltage by the load impedance.
First find the ratio of the transformer. 6600/220 volts. Second find the secondary current, I = W/E, 99000/220. Third divide the secondary current by the transformer ratio. The answer will be the primary current. To check your answer (W (or VA) = V x A) multiply the primary current times the primary voltage and the secondary current times the secondary voltage and they should both equal the transformer's kVA.
in welding machine, the transformer used is basically a current transforrmer. so by changing the tap of secondary side of transformer, we can increase or decrease the current in the transformer.
why does have to short-circuit secondary wire of current transformer ?
The secondary current of a transformer is determined by the load and the secondary voltage applied to that load, and this, in turn, will determine the primary current by the inverse of the turns ratio. However, if you are asking about a transformer's rated secondary and primary currents, then you need to divide the transformer's apparent power rating (expressed in volt amperes) by the rated secondary and primary voltages respectively.
The difference between current transformer and potential transformer is that the secondary of a current transformer can not be open circuited while under service whereas that of the potential transformer an be open circuited without any damage to the transformer.