Basically, Remove the rear wheel, remove the wheel bearing cap from the front of the hub. make sure the handbrake is off. so you can get the hub off, Remove the split pin from the nut and then undo the nut. the front bearing will slide out and then to check the rear bearing you will have to remove the rear seal without damaging it, but because its plastic with a steel insert inside it will probably be damaged. Check out the bearing clean and dry but dont dry with compressed air as they will be damaged by spinning without grease. repack bearing or replace and repack bearings, insert new seal and then put hub back on stub axle push all the way on, then put on the outer bearing, allatc washers and nut, tighten nut still allowing the hub to turn without sloppyness, put on grase cap. and your done. Pacnat1
How to remove rear wheel bearings on a 1978 corvette..?
Instructions on how to change the rear hub wheel bearings on a 1996 Chevy cavalier
How do you change the wheel bearings on a Chevrolet aveo 2005
Front or Rear? Both
very carefully with great intent
WOW! Wish I could help you with this one but I didn't even know Chevy had rear bearings on rear wheel drive trucks.
How to replace rear wheel bearings on Lincoln aviator
you don't they are sealed bearings. they will need pressed out of the hub to change them.
To change rear wheel bearings on an Evo VI, jack up the car and remove the transmission tray. Also remove the engine tray and plastic cover of the suspension wishbone. Remove the rear wheels and the axle nut. Take the brake pads off and loosen the screws of the rotor. Remove the hub and the rear wheel bearings. Replace.?æ
What year tracer? Some you need special tool to pull bearings and hub as a unit!
The front wheel bearings need to be pressed into the spindles. This is something an automotive machine shop would normally do. The rear wheel bearings are bolt-on hub assemblies.
How do you fix a rear wheel bearing for a Lexus ls400