Remove the two or three plastic nuts in the corner where you are changing the bulb. Pull back the felt liner and then remove the three 10mm nuts. The light assembly can then come out for you to change the bulb.
how do you change a rear turn signal bulb on a 2010 buick lucerne
Remove the long black plastic trim on the trunk rail. Remove the three nuts holding on the trail light assembly, and pull out. Remove the bad bulb and reinstall. If it is the bulb in the trunk lid, all you have to do is remove the padding and change the bulb.
Open the trunk, there is a cover that is bolted on. Take off the bolts for the cover, and then you can take out the bulb and replace it.
If you are only replacing the bulb, it can be accessed on the back of the high mount housing in the trunk area.
In the trunk remove the carpet trimming in the interior of the trunk. Remove the winged bolts. Turn the light bulb until the gripper is exposed and replace it with the new one.
There is no trunk fuse, check the light bulb and switch in the trunk
You have to remove the grill, front bumper, and plastic protector under the car. It is a terribly poor design and a nightmare when you have to remove the bumper to replace ANY of the front lights.
Changing a headlight bulb in a 2007 Buick Lacrosse can be done easily. Just remove the cover piece and change the bulb.
thru the trunk
just change the bulb!
open trunk there are six hand tightened plastic wing nuts undo all of those the entire assembly will come off then you may change bulbs
=== ===