Note:The accumulator/drier should be replaced whenever the compressor is replaced Caution:On models with a Delco Loc 2 or Theftlock audio system be sure the lockout feature is turned off before proceeding * Have the AC system discharged.Disconnect the neagtive battery cable * Clean the compressor thourghly around the refrigerant line fittings * Remove the serpentine belt * Raise and support it securely vehicle on jackstands * Disconnect the electrical connector from the AC compressor * Disconnect the suction and discharge lines from the compressor.Both lines are mounted to the back of the compressor with a plate secured by one bolt.Plug the open fittings and discard the seals between the plate and compressor * Unbolt and remove the rear compressor mount.It may be necessary to remove the right side engine mount bolt and raise the engine to access the rear compressor mount bolts * Remove the compressor to front bracket bolts and nuts and remove the compressor from the engine compartment
The 1998 Ford E3 50 low pressure air conditioning port is located on the air conditioning compressor. The low pressure port will be on the right hand side of the compressor.
The 1998 Mazda 626 low pressure port for your air conditioning system will be on the top of the air conditioner compressor. The low pressure port will be on the left-hand side of the compressor.
the load of the AC compressor slows the engine
how to check fuse for horn in a 1998 Pontiac sunfire
You can recharge your 1998 Mercury Mystique air conditioning system through the low pressure port. You can find the low pressure port on top of the air conditioning compressor.
Connect your Freon bottle to the low pressure port on your 1998 Chevy S 10 Blazer air conditioning compressor. Discharge the Freon into the compressor. A recharge kit will make this process quite simple.
Both high and low service ports are located on the top of the a/c compressor manifold assembly......
Do you mean the compressor? If so, you should know that the system needs to be discharged prior to removal, and recharged after installation. In the US, Canada and Japan at least, the handling of the refrigerant must be done (legally) by a licensed mechanic due to environmental issues. Other than that, the mechanical procedures are fairly direct. I suggest picking up a Haynes or Chilton manual. It will give you specific directions. FriPilot
what is the specification of the cram shaft of sunfire 1998, motor 2.4
About 5 Liters according to the manual. You can never have too much oil. Nice wheels
Where is the fuse for the a/c compressor on a 1998 ford mustang
It depends on what engine you have. On some you have to remove the housing on the top of the engine which contains the coils etc.