answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you change a brake hose on 2001 Acura CL 3.2?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change a front brake hose?

How do you change front brake hose on a 1997 lincoln


How do you change a car brake hose?

u break the car


How do you change an 1995 Acura Legend starter?

To change a 1995 Acura Legend starter, remove the 4 bolts around the intake pipe and lower radiator hose. Remove the starter and replace with new.


How do you change the top radiator hose on a 2001 Silverado?

you dont


What do you do with no brake pressure on a 2001 Ford Escape?

I've had this problem on my 01 Escape and had to have the front brake hose replaced. According to the mechanic, Ford has had a lot of problems with these hoses. I'm replacing the rear hose tomorrow.


Where does the vacuum hose on the brake booster go on the intake on a 2001 Dodge Neon?

On the left-lower part of the intake manifold (if facing the motor.) The hose runs underneath the manifold.


What is a brake hose?

The hose that your brake fluid flows through when u mash the brakes


How can you get the front piston in the brake caliper to release after the truck has been running and the brake pressed you have change the caliper out but problem still there 96 s10?

replace brake hose they colaspe


Where is the PCV valve located on a 2001 Acura TL?

The PCV valve on the 2001 Acura TL is located on the top of the rear valve cover. It's easy to replace - simply pull it out by hand and remove the attached hose. You have to remove the black plastic cover on top of the engine to access it.


How do you change heater hose 2001 Chevy 4.3 S10?

Drain the coolant, unclamp the old hose, remove the old hose, install the new hose, clamp the new hose in, fill up the coolant.


How do you remove rear caliper on 2006 Malibu?

1. Remove the brake hose to caliper bolt from the brake caliper. 2. Remove the brake hose from the brake caliper. 3. Remove and discard the 2 copper brake hose gaskets. These gaskets may be stuck to the brake caliper and/or the brake hose end. 4. Cap or plug the opening in the brake caliper and the brake hose to prevent fluid loss and contamination. 5. Remove the 2 brake caliper pin bolts. Remove the park brake cable from the caliper. 6. Remove the brake caliper from the brake caliper bracket.


How do you fix a brake hose on a 94 Tacoma?

A defective brake hose must be replaced. There is no way to fix it.