Very simple. Remove engine complete, put on bench fan down, remove water pump and front cover. Remove valve covers tip rockers and remove pushrods slide cam out. Clean block install lifters slide new came in. Install gasket. Put front cover on and waterpump. Slide pushrods in place back under rocker. Install valve cover. Bolt engine back in. Takes no more then 4 hours to do the job. Last one I did cost about 250$ to do. A cam? And a few gaskets is all u need!
You have to completely disassemble the engine to changethe cam. For a good book to help you I recommend the "How to keep your Volkswagen alive" by John Muir.
when do i change a cam belt on a mazda 2
no the cam remains the same,
it has a cam chain , change about 1000,00 miles
On the V6 change it when you change the cam belt. On the 4 cylinder which has a cam chain change it when you have a leak or it fails.
Mazda!when do i change a cam belt
Typical cam belt change interval is 70,000 miles
John Kidd has written: 'CAD/CAM interfaces'
You don't have to change the cam, but a cam that is perfect for a 350 may not be perfect for a 383. Cam manufacturers offer technical assistance to help you select the right cam for your application.
They can be used to advance or retard the cam timing to correct inaccuracies in the cam or change the characteristics of the cam profile.
To change a 305 cam sensor, locate it beside the camshaft. Disconnect the electrical plug of the sensor and remove the hold-down bolt to take off the cam sensor. Replace with new.Ê
when should I change the cam belt on a 2002 VW Passat 1.8S with 48000 on the clock