Disconnect the negative cable from the battery,disconnect the hydraulic line from the slave cylinder.Using a hammer and a punch,drive out the roll pin from the cylinder.The roll pin is the little black thing just below the line
its the brake resivior
how difficult is it to replace the MS on a 1996 Honda accord
under the car ... near the clutch housing .... you cant miss it
2 reasons: 1. There is no fluid in your master cylinder due to a leaking master cylinder or slave cylinder or 2. You blew your clutch
any information on 87 Honda accord with the clutch/
No, but you have to remove the wheel assembly and transmission.
You have to drop the engine and the trans Good luck
You bleed the clutch at the slave cylinder located near the transmission close to the radiator up front.
Check your clutch slave cylinder fluid level it looks like a mini brake fluid bottle
No the clutch is hydraulic.
For Honda Accord, you change the timiing belt every 110,000 miles ( V6 ). The 4 cylinder has a chain that requires no maintenance.
Yes, they are the same.