Disconnect the battery. Using a metric socket and a breaker bar turn the tensioner clockwise and release the belt. Using a metric socket take off the bolt in the middle of the pulley. Use a pulley puller and pull it off.
There is one on each end of the crankshaft. The front main seal is at the pulley and, while the rear main is at the transmission end.
The crankshaft pulley is the large pulley on the lower passenger side of the engine.
The crankshaft position sensor on a 2005 dodge caravan is mounted on the top side of the bell-housing.
Should pull the drive pulley and then you can pop off the old seal with a screw drive and press in the new seal.
The answer is yes.
The crankshaft position sensor on a 2005 dodge grand caravan is mounted on the upper side of the bell housing and can be easily accessed from the top.
The crankshaft position sensor is located at the lower left hand side of the crankshaft pulley. The crankshaft pulley is the large pulley located in the center lower portion of the front of the engine.
The crankshaft position sensor on a 1998 3.0 dodge caravan is located on the top of the bellhousing towards the firewall.
yes
trany bell housing
on the top of the truck
It is inside the engine, on the front of the crankshaft.