Dashboard Lights and Gauges
Geo Metro
DIY Projects

How do you change a dash light in a 1995 Geo Metro?

313233

Top Answer
User Avatar
Wiki User
2006-06-28 23:14:09
2006-06-28 23:14:09

You have to remove the instrument cluster. Easy job to do if you're the least bit handy with a Phillips head screwdriver.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

How do you change dash board lights on a 1995 Mercury Tracer.

User Avatar

the dash lights went out in our older 1995 monti Carlo does the whole dash need to be taken apart or are you able to change lamps from behind

User Avatar

That is the dash light dimmer control switch.. Rheostat = Dimmer. Bright to dim.

User Avatar

my 97 grand am se dash light want come on i change all of the fuse

User Avatar

The '93 is under the dash, hidden above the fuse box, by the driver's left foot.

User Avatar

It might be in the dash bored of the car.

User Avatar

On the right side of the instrument cluster.

User Avatar

you need to reset the reminder light...check online or manual for instructions

User Avatar

Passenger side right wall under the dash. You need to pull up some carpet to get to it.

User Avatar

i have dash light problems also and my easy fix is just hitting the dash . the lights all work again after i do!

User Avatar

is it a warning light or the dash backlight you want to change ????

User Avatar

The signal and 4-way flashers are behind the lower dash panel, aprox under the radio. The lower dash panel must be removed to gain access to the flashers.

User Avatar

In the fuse box under the dash. The one you are looking for is most likely called "instrument lights".

User Avatar

reach up under the dash with your hand and each one is in a socket that you twist out to change the bulb, there are no wires attached to the sockets as the dash is solid state.

User Avatar

To change the dash light bulbs you must remove the instrument panel.

User Avatar

I have a 1995 neon dodge and my dash lights will not come on or my tail lights and every time i change the airbag fuse and turn on the car the airbag fuse blows.

User Avatar

There is a problem with the ABS. Take it to a professional.

User Avatar

You have to remove the instrument cluster to get access to the bulbs.

User Avatar

2 are the instrument light dimmer buttons and the other is 2 reset the service light

User Avatar

The brake light fuse on a 1995 Acura Integra is located inside the cabin of the vehicle. It is on the same circuit as the dash and hazard lights.

User Avatar

A likely cause is a faulty interior light dimming switch. This switch is directly connected to both the dash lights (for dimming), and the dome light (on/off).

User Avatar

the heater core is behind the dash, most of the dash needs to come out and i would get a Chilton or Haynes book.

User Avatar

i do not yet doing that but i just know that the light for the gearshift is located at the dash board light


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.