Answer ~Bad but not too complicated.There are a row of Allen head and 9/16 nut screws on the bottom panel below the steering wheel and middle panel, remove those.Gently pull down lower panel, upper panel will pull out as well slightly. The hazard flasher (left) and turn signal (right) are just to the left of the lighter assembly. (Silver)Relays are difficult to pull out, if you gently use wide mouth pliers , rock them out. Replace and test, before reinstalling panel.
where is my voltage regulator located on my 1997 gmc jimmy
The cause for a turn signal flasher to keep clicking on a 1999 GMC Jimmy is a bad flasher unit. Replacing this with a new flasher unit should solve this problem.
there are two flasher boxes under the steering columb to the right change the flasher it should be a two prong silver canister any auto parts store it's called a flasher
The towing capacity of a 1997 GMC Jimmy is 4,500 pounds. This allows it to pull small trailers and boats.
howdo you change an ignition switch on a 1996 gmc jimmy howdo you change an ignition switch on a 1996 gmc jimmy
how to re & re fuel level module on 1997 jimmy
How do you change the abs pump on a 2001 gmc jimmy
Most likely the turn signal flasher.
what kind of transmission s in my 97 gmc jimmy 4x4?
take dash board off the core is located driverside near floor board
Go to autozone and they will show you...
I get about 17city/20highway