You must remove the headlight assembly to get working access to the bulb.
Remove the long top outside Torx screw (T30), and the short one.
Slide assembly forward. Use a very small screwdriver to bend back the 2 locking tabs to release the plug. Slide plug straight out.
Then rotate black plastic collar ccw to release the bulb. Bulb pulls straight out.
When installing the new bulb (9007 series), align bulb notches with housing, push it in, then lock in the collar clockwise. Replace that plug, and turn signal plug.
Avoid touching the new bulb with your bare hands. Also wise to replace the amber turn signal bulb at the same time, while you have access to it.
Get the headlight, and see if its just a bulb(from the rear installs) or it's the entire light(installs from the front) ..a library will most likely have a shop manual for free
engine needs to be removed
100,000 miles.
Yes it can be done in vehicle.Yes it can be done in vehicle.
Just under 5 qts with filter change. (approx 4.8 qts)
No the Chrysler Sebring did not have that feature until 2008.
The driver side front tire, and inner fender liner need removed.
i have a 96 was alsolooking into changing top look on ebay there is a guywho sells tops with an instructual dvd for installation
A 2000 Chrysler Sebring was not built with a cabin filter.
where do I find the battery on a 1999 Chrysler sebring, can't find it in the engine compartment?
A 1999 Chrysler Sebring does not have a mass airflow sensor.
Change the fuse dummy