0
What gets removed to change the battery on a 1998 Chrysler Sebring convertible jx?
Wiki User
∙ 10y ago
The driver side front tire, and inner fender liner need removed.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
How do you change expansion plugs on 1997 Chrysler Sebring Convertible?
engine needs to be removed
Where is the convertible top pump on a 1997 Chrysler Sebring?
It is behind the rear seat back. The seat has to be removed to access.
How can you get the rainwater out your 1997 convertible Chrysler sebring?
Shop vac. There are plugs in the rear wheel wells which need to be removed for the water to drain.
How do you pull the 2.7 in a 2002 Chrysler Sebring convertible?
The engine and transmission are removed together out the bottom.The engine and transmission are removed together out the bottom.
Where is battery located on a Chrysler sebring?
under the driver side front fender the wheel must be removed for access.
Location of shift solenoid b for 97 Chrysler sebring convertible?
The shift solenoid B for a 1997 Chrysler Convertible is located inside the transmission. The speed sensor has to be removed to access the bolts to remove the cover over this shift solenoid.
Where are the spark plugs located on a 2000 Chrysler sebring convertible?
Down the middle of the valve covers. On a V6 the intake has to be removed to access the rear three.
DO you have to drop the fuel tank on a 1998 Chrysler Sebring convertible to replace the fuel pump?
Yes. The fuel tank must be removed to access the pump.
Where is the thermostat in a 2004 Chrysler Sebring convertible?
The thermostat for a 2004 Sebring Convertable is in under the water outlet for the BOTTOM radiator hose. This is behind the alternator which will have to be removed, after you remove the belts. Plan on an afternoon of work. Hope this helps.
Where is the battery located on a 2004 Chrysler sebring?
2000 Chrysler sebring,to replace battery car must go to dealer to have fender removed so new battery can be installed, they charge $169.00 for this work. Or they remove it through the hatch in the wheel well. Turn wheel fully left. Disconnect terminals. Remove the panel from the left wheel well. Remove the battery hold-down
What kind and where is the battery on a 1998 Chrysler Sebring LX?
The type of batter needed for a 1998 Chrysler Sebring LX is a 12 volt or 525 cranking amps battery. The batter is located in the front of the driver side wheel well under a plastic shield that will need to be removed. You will need to turn your steering wheel all the way into the left position to access the battery.
How do you replace the battery in a 2001 Chrysler Sebring convertible?
The front bumper skirt must be removed first. There are a couple of bolts on each side just forward of the front tires. Then there are several plastic push fasteners across the top under the hood. Once the skirting is removed the battery can be seen just forward of the Left front tire. Good luck. All that needs removed is the inner fender liner in front of the driver side wheel. You can then access the battery.
