You need to remove the two fairing pockets. Then yoy can get to the front light bulbs. The space in there is narrow so this may not be easy for people with large hands, however it should be managable giving it a little patience. Don't touch halogen lighbulbs with your bare fingers, use thin rubber gloves such as can be bought in farmacies.
To change the high beam headlight on a 2008 Honda Goldwing you first have to remove the headlight housing by taking the six bolts off. After you remove the cover it is as simple as disconnecting the wiring and then pulling the light out.
You Have a bad headlight, it's common when a headlight burns out for only the high beam to work, solution change your headlight.
On a four headlight system there are two filaments for the inner lights. They have a filament for a high beam and one for a low beam.
Carry it to dealer who will replace on low beam headlight for $15 +/- dollars in about 5 minutes.
Begin by removing the wiring harness from the back of your 1989 Silverado headlight assembly. Remove the low beam headlight assembly retaining bolts. Reverse the process to install your new low beam headlight.
with ur hands
please answer the question
You can access the low beam headlight bulb from the engine compartment. Push the bulb holder in and turn. The bulb will come out.
The Low Beam AND High Beam are in the same bulb. The procedure to change it will be in the owners manual.
headlight bulbs changed,dimmer swich changed,headlight swich changed.key off headlight work low ,key on goes to brights. unpluged harness check ok at first ,but after a few try hi beam indictor would not go to low m-beam
replace passenger side low beam headlight
adjust headlight beam on 2010 xtrail