Want this question answered?
what do you have to do to change the center brake light
how to change third or center brake light on Chevy beretta 95
The way that you change a high mount brake light on a 2007 Taurus is by first prying the light assembly from the housing. You then push rearward to remove it from the retaining clips. Next, life the light assembly from the shelf and disconnect the assembly wiring. Replace the light assembly and reverse directions to put the light housing back where it goes.
If you mean the red " BRAKE " light in your dash is on , that means that the brake fluid level in the brake master cylinder located in your engine compartment ( on a Ford Taurus ) is LOW ( or that the parking brake is on )
On a 1999 Ford Taurus : The oil pressure warning light is just to the right of the tachometer * just above the parking brake / emergency brake , brake fluid level warning light
The center brake light replacement will require replacing the entire brake light assembly. Remove the wiring harness. Remove the center brake light retaining screws. Reverse the process to install the new center brake light.
Begin by removing the wiring harness from your third brake light. Remove the third brake light retaining screws. Reverse the process to install your new third brake light.
Check bulbs?
yes it dose
WHICH brake light?
see owners manual. its easy to do
If you are referring to the warning light on your instrumentation panel, then you simply need to check all your brake lights, do not forget the center one at the rear glass.