answersLogoWhite

0


Best Answer

Remove the kick panel covers, the lower portion of the dash, remove the lower half of the covers on the steering column. You will have to cut about 3 or 4 wire ties. you will need a special tool to remove the bolts from the existing ignition switch, (it looks like a reverse torx screw). To remove the other end of the existing Ignition switch cable you will need a nut driver to remove the connector. Remove the two additional connectors on the outside of the connection. Re-install the additional connectors onto the new switch harness. Connect the adaptor and tighten the bolt. install the switch and tie the harness back into place. replace the cover and Dash panels.

User Avatar

Wiki User

โˆ™ 2008-07-21 19:11:04
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change a ignition switch a 1993 gmc truck sonoma?
Write your answer...
Submit
Related questions

How do you change the ignition switch on a 2004 gmc 1500 sierra truck?

how to remove cover to replace ignition lock cylinder and what type of tools do i need


How doi remove ignition without key from 1986 Toyota pickup truck?

Begin by removing the retaining ring at the top of your 1986 Toyota pickup truck ignition switch. The ignition switch will slide out. Remove the wiring harness from the back of the ignition switch.


How do you replace an ignition switch for a 1977 Chevrolet truck?

n ignition switch on a 1991 Chevrolet astro vanAnswern ignition switch on a 1991 Chevrolet astro van


Wiring diagram for ignition switch for 1974 Chevy truck?

Ignition wiring diagram


Key turn truck on but will not turn truck off?

Probably a bad ignition switch.


How do you change the ignition switch on a 1989 Ford truck?

I just purchase a f150 that needs a new ignition switch and the man at auto zone gave me directions with pictures and diagrams, I hope this is of some use. Good Luck!


When I start my 1997 V6 Sonoma it starts then stops Does that a few times then goes all right Sometimes while driving it will die then go again?

My 97 Sonoma was doing the same thing and a good tech found it was a bad ignition switch. The truck runs great again.


How do you replace the ignition switch on a 1985 Chevy truck?

replace ighnition switch for 1985 chevlot


Where is the relay switch on 1993 Sonoma truck?

It is under the dash with some wires plugged into it. At least that where it is on mine.


How do you remove the ignition switch cylinder to replace it on a 1971 Chevy truck with no key?

With no key you will have to drill out the existing tumbler assembly from the switch in order to unscrew the ignition switch bezel.


How do you remove an ignition switch from a 1979 Chevrolet C10 pickup?

Remove the retaining ring from the top of your 1979 Chevrolet C 10 pickup truck ignition switch. Slide the ignition switch out and remove the wiring harness.


How do remove the ignition switch on 1978 Chevy truck?

High-powered explosives.


Why would my truck not start with aNew starter battery alternator?

check the wiring change the starter relay and clean ignition switch with electicial cleaner.


How do you know if ignition switch is in run position?

if the starter is not spinning and the truck motor is running


How do you repair an ignition switch on a 1992 GMC Sierra 1500 pick up truck?

Do you take the steering wheel off to get to the ignition


How do you start truck without ignition switch switch was ripped out?

The right wires will have to be connected. You will need a wiring diagram to figure out the order.


Why is there no power to the ignition switch?

normally a fuse but the switch needs to be connected to something i.e car, bike, monster truck etc


Why does freightliner truck engine keep running with key turned off?

Faulty ignition switch.


How do you replace the ignition switch on 1995 F-350?

1995 ford 350 1 ton box truck ignition replacement


Will a bad ignition switch shut down the electrical system on a 1994 Chevy truck?

A bad ignition switch can shut down a vehicle's electrical system. Ignition switches have been the cause of a major recall by General Motors.


1989 Honda accord 20 l Start then dies immediately It has fuel to filter and to the fuel rail and to regulator?

I had a similar problem on a Ford truck and it turned out to be the ignition switch. The truck would start just fine but when I released the ignition key the truck would die. I replaced the switch and problem was gone.


How do you install ignition switch 1988 gmc truck?

You need to remove the steering wheel first with a puller. There is a latch you can trip with a small screwdriver that will let the ignition switch slide out. Simply replace the switch and put the steering wheel back on.


Why does radio stop working when 2006 Ford Ranger truck is started?

Possible bad ignition switch


How do you change the ignition switch on an 87 Chevy C-10 pickup truck?

you have to remove the steering wheel, after that you need a tool to releave the tenison on the plate that looks like a sun there is a clip to remove. after that if you look where the switch is you will see a screw, if you remove it the switch will come out.


Where is the starter ignition switch on a 1990 Chevy Cheyenne 1500?

95 truck manthe ignition switch is the thing you stick your truck key into to start the motor.the starter is under the hood,located at the bottom of the engine.follow the "hot" lead frpm the battery.goes right to the starter motor. Nope, this guy is wrong. The thing you stick your key in is the ignition cylinder or lock. The ignition switch is a separate unit. Both are available for replacement. The cylinder itself is just a mechanical unit which operates the electro-mechanical ignition switch located a bit further down the column.