Toyota Corolla

How do you change a license plate bulb on a 2001 Toyota Corolla?

272829

Top Answer
User Avatar
Wiki User
2007-02-15 22:03:36
2007-02-15 22:03:36

U need a screw driver, open the trunk and at the latch there is a screw that holds the bulbs unscrew and replace the bulb, u might have to take the inside dash out but is easy to put back on

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Changing a rear license plate light on a 1991 Toyota Corolla will be very easy to do. You need to take the license plate off and then unscrew all the plastic screws holding the light cover in place. After the screws are out, remove the cover and unscrew the old bulb and replace it with a new one.

User Avatar

how do u change the license plate light on a 2005 sienna

User Avatar

The 2001 Toyota Camry license plate light fuse can be found in the fuse box. The license plate fuse will be labeled as the tail light fuse.

User Avatar

There are plastic bulb covers on either side of the license plate. Unscrew the screws and take the covers off. From there you can insert new bulbs.

User Avatar

How do you change the lamp on the license plate of a lincoln ls 2000?

User Avatar

Open the trunk and look for the wires that connect to the license plate lights. You should see a plastic piece that hooks into a socket. Simply grab the plastic piece and turn and the lights should come right out. The lights may be behind a paneling.

User Avatar

Passenger side kick panel fuse #13, 10 amp, same fuse for trunk light, license plate light, interior light(s)

User Avatar

how do you change the light bulb over the license plate on 2000 eclipse

User Avatar

No. The licence plate cannot be altered.

User Avatar

The gear shift lamp on a 2006 Toyota Corolla can be replaced by taking apart the gear shift plate and replacing the bulb. This can be a very complicated procedure. The top of the gear shift plate is held on by clips at the front and back.

User Avatar

how to change 2005 equinox license plate light i removed the screws but it didn't release

User Avatar

How do I change the license plate bulb on a 1993 Lexus ES 300

User Avatar

how do you change the rear license plate light on a 1999 Buick Regal

User Avatar

No there will be additional charge for getting your license plate changed

User Avatar

It is very easy to change the license plate light on an Oldsmobile Aurora. All you need to do is remove the license plate and look above where the plate was. There are bolts that are holding the light in. Unscrew the bolts and then replace the light.

User Avatar

VIN plate location on 2008 Corolla Hatchback is inside the front passenger door on a black label, below the door latch.

User Avatar

Remove 1. Bolts retaining license plate lamp to bumper. 2. Socket from license plate lamp. 3. License plate lamp. 4. Bulb from socket. Install or Connect 1. New bulb to socket. 2. Socket to license plate lamp. 3. License plate lamp. 4. Bolts to retain license plate lamp to bumper.

User Avatar

on the 2001 XZ3 I removed the license plate and used a flat head screw driver to slid the license plate light cover over and they "pop" out.

User Avatar

Phillips screwdriver...two screws throught the lens. Remove the lens and extract the lamp. It pulls out.

User Avatar

If they obscure ANY part of the information on the plate, OR change the colors of the plate - YES.

User Avatar

you can find the horns in the grille.both opposite side of the license plate.

User Avatar

The Toyota Corolla is equipped with a timing belt. Whether the need for a timing belt replacement is dependent upon many different factors. If the engine is not running at all you probably will need a timing belt.

User Avatar

how incomptent are you not to see the 2 screws holding the plate on????????????????


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.