Drain the old one, disconnect the transmission lines, undo the radiator hoses and bolts holding it in an pull it straight up.
Should be at the engine end of the upper radiator hose
R134
p185/65/14
Same answer as: "How do you replace a starter on a 92 Geo Prism LSI or GSI?" at this same site.
To replace the water pump on a 1996 Geo Prism, start by disconnecting the negative battery cable and draining the coolant. Remove the serpentine belt, then unbolt and take out the water pump from the engine block. After replacing the water pump, reattach the radiator hose, ensuring a secure fit. Finally, refill the cooling system with coolant, reattach the battery cable, and check for leaks.
it is right under the motor. it will be black with a bolt sticking out on the botom of it.
Remove the bottom radiator hose. Stick a hose in the top of the radiator. Turn the water on. Allow the water to run through the radiator and out the bottom of the radiator.
Who cares... those cars suck
To flush the radiator on a 1997 Geo Prism, start by ensuring the engine is cool and then remove the radiator cap. Place a container under the radiator and open the drain valve at the bottom to let the old coolant drain out. After draining, close the valve, fill the radiator with a radiator flush solution and water, run the engine for about 10-15 minutes, then drain again. Finally, refill the radiator with the appropriate coolant mixture, and replace the cap.
Answered by this question:Using the vin numbers to tell which model Geo Prizm you have?
if your talking about a cabin air filter (not equiped)
The fuel capacity is 13 US gallons