0
Open back the access panel in the boot, behind light, put your hand into opening, press in tab on light holder and take it, and the bulbs out. Push in and release the non-working light bulb, and replace it (21/5 w combination bulb). Refit light holder, this can be tricky, push it gently slightly downwards until i+t clicks solidly into place. Test all rear lights and if ok replace access panel in boot. Job done, simples
Make sure to check the lights a week afterwards, the light holders have a habit of coming away from their mountings if they are not clipped in correctly, this leaves No Lights showing and a unit submerged behind the cover.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What fuse do you change on a 2008 Hyundai elantra if the rear brake lights and third rear brake lights do not work?
it would be the brake light switch about 20 dollars at autozone
Reset oil service light on Ford Mondeo diesel 2008?
put ur car on ignition without starting engine and press down acclater and brake padel for at least 20 seconds and problem will be solved thanks
Where is the brake light switch in a 2008 freightliner M2?
Attached to the brake pedal.
How do you put the oil service light out on a 2008 mondeo diesel?
1. Close all doors.2. Turn the ignition key to position II.3. Simultaneously press the accelerator pedal and the brake pedal and hold for a minimum of 15 seconds.4. The oil change reminder indicator will turn off. This confirms that the reset procedure has been correctly completed.
How do you change the high brake light bulb on 2008 kia optima?
There are two screws under the back dash that need to be removed to lift the assembly off the back dash. I had a problem with the same car. No brake lights at all. I disconnected the power to the third light and the main two brake lights started to work. There must be a short in the third brake light harness.
How do you change brake light on 2008 Nissan rogue?
2008 Nissan Rogue brake light bulb replacement: Purchase the correct replacement brake light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement brake light bulb information. Then consult your owner's manual for the replacement procedure. As simple as it sounds, the owner's manual is the best place to start for brake light bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
How do you change brake light on 2008 Chevy Cobalt?
2008 Chevrolet Cobalt brake light bulb replacement: Purchase the correct replacement brake light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement brake light bulb information. Then consult your owner's manual for the replacement procedure. As simple as it sounds, the owner's manual is the best place to start for brake light bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
How do you change rear brake pads a d rotors on a 2008 Montana sv6?
How do you change the rear brakes on a 2008 Montana
How do you change the brake light bulb in a 2008 Toyota Highlander sport?
2008 Toyota Highlander brake light bulb replacement: Purchase the correct replacement brake light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement brake light bulb information. Then consult your owner's manual for the replacement procedure. As simple as it sounds, the owner's manual is the best place to start for brake light bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
How do you change the bulb in the third brake light on a 2008 Chrysler town and country limited van?
Which model of chrysler van? Resubmit the question with make, MODEL and year.
What does the brake light mean on a 2008 dodge charger?
Which light are you asking about? Dashboard location would help -- Brake lights mean the brake is being applied, but I'm sure that's not what you're asking.
Where is the brake light fuse for a Chevy Colorado 2008?
It's in the left engine compartment.
