The ventures serpentine belt can be removed and replaced by releasing pressure on the tensioner. Just take your large socket wrench and insert the square head into the square slot on the tensioner and use it to release tension on the belt. The tensioner is the triangle-shaped arm located just a bit below the alternator. Carefully remove the old belt and then replace the belt as shown on the diagram located on the belt guard. You can put most of the belt in place before using your wrench again to release the tension and finish putting the belt in place. It helps to have a long wrench. I used a socket extension that I attached to the handle. It took me less than 5 minutes. It was pretty much like resetting the chain on a 10 speed bike.
To change the ignition lock cylinder in a 2001 Chevrolet Tracker, first disarm the air bag system. Then remove the clock spring assembly to be able to remove the old ignition lock cylinder and replace with a new.
The 2001 Chevrolet Tracker starter relay is mounted on the top of the starter. The relay switch is attached to the starter with two retaining screws.
I currently have 213,000 and hope to get another 100,000!
how do you change the serpentine belt on a 2001 Rodeo
I need to know if I need a special to to change my serpentine belt on a 2001 Buick Regal
Yes, the 2001 ignition switch for a 2000 Chevrolet Tracker will fit just fine. Other years the switch fits are 1999 to 2004.
Signs of: Cracking Wear Glazing Slippage It is original after 6 years?
how to replace wiper transmission assembly on a 2001 tracker
Being surprised my 2001 Suzuki Grand Vitara (same as Tracker) had a drain plug for the transmission. I just change the fluid, not the filter or gasket.
Both the lens and the light pull out.
I have a 2001 Tracker and it has a 17 gal. tank. I've got a '98 Tracker, and I recall reading that it has a 14 gallon capacity I ve got a 94 Tracker and I can only squeeze 10 gallons of gas into it
have someone check your starter out i had the same trouble and it was my starter