First disconnect the ground wire from the battery. Then detach the wires from the starter solenoid, taking note of where each wire was so they can be put back later. There may be a rear support bracket on the back of the starter, if yes remove it. Then remove the two bolts that hold the starter to the bottom of the block They are 15mm heads, you will need a socket and extension plus driver to remove them. Then the starter will slide towards the front of the motor and come out.
As for removing the solenoid. Remove the screw that attaches a copper bus that comes out of the starter body to the solenoid. Then remove the two screws that hold the solenoid to the starter, twist the solenoid slightly and remove it from the starter. There will be a spring inside that will come off, retain it for reassembly if you need it.
To put it all back together reverse the dis-assembly order.
Are you asking about the starter solenoid? If yes it is on the starter. If you are not asking about the starter solenoid what are you asking about?
Assume you mean starter solenoid; most GM starters have the solenoid built in. To change it, just replace the starter.
Starter solenoid?
The solenoid is on the starter.
It is mounted on the starter motor itself. When you get another starter, it will have the solenoid mounted on it already. If it is bad, just replace the starter, I would not change just the solenoid.
The starter solenoid is mounted to the starter.
A starter solenoid on a Chevy El Camino is mounted directly to the starter.
I DO BELIEVE THE SOLENOID IS MOUNTED ON THE STARTER AND YOU WOULD HAVE TO REPLACE THE STARTER TO REPLACE THE SOLENOID remove the starter and take it down to your local auto parts store. they can bench test the starter and give you the proper solenoid if it needs to be replaced.
The starter solenoid is located on the starter. It would be more cost-effective to have the entire starter replaced with a good remanufactured unit on this application.
The starter solenoid on a 1998 Chevy 1500 is located on the starter. It is on the top with a positive cable connecting it to the starter.
The starter solenoid is attached to the starter.
If you are looking for the starter solenoid, it is attached to the starter.