it requires a slide tool to push u clip out. most parts store have tool
How do you install a rear sliding window on a 2000 Ford Ranger?
on the floor
How to remove 2000 ford ranger rear window. Need to replace would like to replace with a sliding window need instructions how to do it
Yes.
how do you change a fuel filter and were is it located on a 2000 xlt ford ranger
How to repair power window in 2000 Ford Ranger passenger window will not work with either drivers button or passenger button the relay does not make any clicking noise either What is wrong?
Most window handles are either held on with a screw or a clip. Your has a clip and you need a window handle removal tool to get the clip off. They are inexpensive and most auto parts stores sell them.
What is a carbon dioxide sensor?
2000 Ford Ranger Answer There is a thin plastic cover over the window crank handle. It pops out at the large end of the crank (the bottom) and will rotate out of the way so that you can get at the torx screw. The torx screw holds the handle to the shaft. It goes through the center of the shaft. You can use a flat screwdriver to gently pry the cover away from the large end of the crank handle. No special tool is needed. Once you have the handle off remove two other screws, one at the bottom of the door panel and one in the door arm rest. Then grasp the panel at the bottom and slide up to remove. There are no snap pins holding the panel in place. It slides up and off of the door latch for removal.
Yes, you can change the shifter handle. Remove the hairpin clip at the front side of the handle and lift the handle from the metal pipe.
I checked motorcraft.com , and the owners manual for a 2000 Ford Ranger and they both indicate that the only 4 cylinder engine in a 2000 Ford Ranger is a 2.5 L. With filter change it takes 4.5 quarts ( 4.3 liters )
can you use a transmission from a 1993 ford ranger in a 2000 ford ranger?