Disconnect it from the Box under the battery, clip the zip-tie and lay it loose. Disconnect it from the Pedal. Back under the hood, remove the plug from the firewall and the cable will come right out. Very EASY, far more easy that finding the replacement part.
the hole dash has to come out . just change mine in a 02 dodge ram 1500.
Putting your foot down too hard on the accelerator.
how do you change the speedo cable on a 99 goldwing 1500, and how do you lube the front end/ I need instructions, not parts
The speedometer does not have a cable on a 1994. It is run by a sesnor on the rear of the trans/t-case.
replace the throttle cable.
No.
The bolts on the starter take a 5/8 inch wrench. The battery cable is a 13mm wrench.
No. You can not change to OBD 2.
It doesn't have a speedometer cable. It is electronic.
Throttle Position Sensor(TPS)/Accelerator Pedal Position Sensor(APPS) signal voltage high.
ya
To reset an alarm on a 2001 Dodge Ram 1500, disconnect the battery cable for 10 minutes. Users can also disable the alarm by inserting the key into the door.