answersLogoWhite

0


Best Answer
Copy

Remove the vacuum line than attach it to the EGR. With the valve open and lifted, suck on the line and spray on the valve. You should also have a new gasket to replace the existing one. Check all the hose connections

User Avatar

Wiki User

โˆ™ 2014-09-18 00:22:28
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: How do you change an EGR valve on a 1992 Mazda Protege?
Write your answer...
Submit

Related Questions

Where is the EGR valve on a 1992 Mazda Protege?

Were is the egr on a 1992 mazda protege


Where is the headlight relay in 1992 Mazda Protege?

Where is the headlight relay in 1992 Mazda Protege?"


Does a 1992 Mazda Protege have ABS?

No.


Can a single overhead head for a 1992 Mazda protege work can on a double overhead block for a 1992 Mazda protege?

DONT BE STUPID


Where is the fuel pump on a 1992 Mazda Protege?

In the gas tank.


Where's the block heater on a 1992 Mazda Protege?

My 92 Protege didn't have a block heater, I had to get one installed.


What does a blinking Hold Light on a 1992 Mazda Protege mean?

tranny problems


Where is the Diagnostic port on a 1992 Mazda Protege?

Near the battery. It will have "DIAGNOSTIC" on the cover.


What is the tire size for a Mazda Protege?

for a 1992 it's 13" for a 1992 it's 13" P175/70/R13


On your 1992 Mazda Protege LX when the gas pedal is pressed all the way down it barely accelerates and stutters and when idleing the rpm needle shakes and sometimes it dies?

not my Mazda protege lx


Why would a transmission slip in drive when the fluid level is full for a 1992 Mazda protege?

do a full fluid change ,you might have small particulates in the holding tank


How do you reset the tps ona 1992 Mazda protege throttle position sensor?

check the manual


What is the oil capacity on a 1992 Mazda Protege LX 5-speed?

It should hold 4.5 qrts.


Your 1992 Mazda Protege DX is running hot.Radiator replaced could it be the water pump?

Check the engine thermostat.


Your brake light sw is working and your brake lights still remain on for your 1992 Mazda Protege?

Switch is defective or out of adjustment.


What are the valve clearances for a 1992 Mazda Astina?

.012 on intake .010 on exhaust


Where is the egr valve located on a 1992 Mazda b2600i?

I Called the Mazda dealer today and talked with the Mazda Tech and asked him the location of the EGR valve on the 1992 Mazda b2600i. According to the tech only the California models have an EGR valve, I would think that any state with similar laws about vehicle emmisions would require the egr valve also. My truck is from Montana and it doesn't have an egr valve which explaines why I havent been able to find it.


Your 1992 Mazda Protege will turn over but wont start what could be wrong?

battery may be dying and altenater may be going out


Will a 1994 Mazda Protege turn switch signal fit in a 1992 Mazda Protege?

Yes. Mazda part numbers: w/Cruise Control BR75-66-120D w/o Cruise Control BR72-66-120G w/o Intermittent Wiper ("INT" position on stick) BR70-66-120G


You have a 1992 Mazda Protege hold light remains on?

I suspect your hold switch on the shift lever might be bad..or ahs a broken wire.


How do you disable the horn on a 1992 Mazda Protege?

Open hood and disconnect the wire from the horn itself located under right front fender.


Where is the heater core located on a 1992 Mazda Protege?

In dash. Look for 2 hoses on firewall-it's behind them. Replacement is not a job for a novice.


How do you change a headlight in a 1992 Mazda miata?

same as the 1994


How do you check the level of the manual transmission fluid of a 1992 Mazda Protege?

Should be a plug at the side of transmission - fill to oil starts coming out of this plug


Can you use a 155 80R 13 tire for a 98 mazda protege?

You could if you had 1992, 1993 or 1994. 165/80/13 will be your best bet.