answersLogoWhite

0


Best Answer

you have to go under the dash and take out the steering column. and the ignition switch should have a wire going down to the bottom of the column coming from the ignition lock.

User Avatar

Wiki User

โˆ™ 2008-12-05 06:16:02
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do you change an ignition switch on a 1990 Cadallic?
Write your answer...
Submit
Related questions

How do you change the ignition switch on a 1990 Cadillac DeVille?

Take it to a shop


Instructions on how to remove ignition switch on a 1990 Lexus LS400?

Remove the retaining ring from the top of your 1990 Lexus ignition switch. The ignition switch will slide out. Remove the wiring harness.


Replace ignitio switch in a 1990 Pontiac Bonneville?

Begin by removing the retaining ring at the top of your 1990 Pontiac Bonneville ignition switch. The ignition switch will slide out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install your new ignition switch.


How do you remove the ignition switch on a 1990 Chevy half ton pickup?

how do you remove the ignition switch on a 1990 chevy half ton pick-up?


How do you change the ignition switch in a 1990 Pontiac Grand Prix without pulling the steering column?

the ign switch or the key & tumbler ???


Where is the ignition switch on a 1990 bronco xlt located?

The ignition lock is where you put the key. The ignition switch is located on the top of the steering column directly above the brake pedal.


Why does your key not turn in your ignition in your 1990 dodge ram van?

Bad ignition switch or wrong key.Just replace with new switch about $10.00 NAPA


Where is the ignition switch located on a 1990 Cadillac DeVille?

On the steering column????


Can the ignition switch in a 1990 Chevy pick up cause the transmission to not shift?

NO, there is no coalition between the ignition switch and the transmission. The ignition switch does 2 things. Turns on power to the electrical system for the engine and supplies power to the starter during start-up.


Is there a way to change the ignition switch on a 1990 Pontiac Grand Prix 3.1 liter automatic transmission tilt steering without pulling the column?

YES


1990 Mercury Cougar won't start how can you jump or eliminate the switch on the brake?

Your brake light ignition switch should be replaced. It works your brake lights and ignition switch, so you do need it. It only costs about $7 dollars.


Your 1990 Honda accord won't start and you can push start it but can't start from the ignition switch?

might be something with starter/solenoid assembly or the crank wire circuit coming from the ignition switch.


You lost your keys to your 1990 sedan deville you bought a new ignition switch from pep boys the new key that came with the switch doesn't have a chipresistor in it will this switch key work?

no


What would cause no electrical power to the ignition switch of a 1990 ford f150?

Ignition relay is probably shot. It is in the power distribution block in the motor comprtment.


Is an ECM and ignition switch the same part difference on a jeep wrangler 1990 2.5?

No! The ECM is the Electronic Control Module (Computer), sometimes called ECU, Electronic Control Unit. The ignition switch is just that, the switch that controls the engine ignition, the power to the starter, starting and shutting the engine off, and power to the accessories.


How do you change the ignition switch on a 1990 Oldsmobile Cutlass Ciera?

I believe you need to pull the steering wheel off and get in the steering column that way. I had this done on a previous car, (expensive) so this time I just hot wired to the starter and added a tago switch.


How do you remove the ignition switch in a 1990 Pontiac Grand Am?

i have a 2003 Pontiac grand am, no start, does not even turn over. could it be the ignition switch?


Where can you find Step by step on how to replace ignition switch on a 1990 lumina?

Replacing the ignition switch is very simple. When you purchase the new switch it will give you photos adn simple instruction to follow. Youy will need some toolls. Good luck and God bless you. lemon Pro


How can you bypass a neutral safety switch on a 1990 Nissan D21 Hardbody with a 3.0 V6 Manuel Transmission?

It doesn't have one, it has a switch on the clutch pedal. It also has an interlock switch on the dash, turn the ignition switch on and press the interlock switch and it will bypass the clutch switch.


Your 1990 Bronco will not shut off after the key is turned off and removed Is this the ignition switch The check eng light stays on after coil wire is pulled It still has power?

It is very possibly the ignition switch but there are certainly other possibilities as well. In any case, you'll need to learn some electrical diagnostic skills. The ignition switch appears faulty.


Ignition wiring diagram for a 1990 Ford Mustang gt 5.0?

The diagrams for the wiring of the ignition switch on a 1990 Ford Mustang 5.0 can be found on a website called Sbf Tech. Many of the other wiring diagrams for the 5.0 can be found there also.


How do you change the ignition switch on a ford 1990 f150 truck?

on the ignition switch down by the hazard light control you will see a pin hole turn the lock cylinder to run push a small punch eighth inch iI think may bre smaller.then you will be able to slide the cylinder out may have to pry a little. If you don't have the key you will have to drill the pin out.


Where is the Ignition Back-up light switch located on a 1990 Dodge Dakota?

Pretty sure it's on the driver's side transmission. It's integrated with the neutral safety switch...


1990 ford f150 ignition switch replacement anywhere to obtain a diagram on-line?

http://www.dslreports.com/forum/remark,15171433


Why is my 1990 bronco 5.0 key is hard to turn wont start?

Probably wore out ignition key or switch or needs lubrication.