The question you ask is tooinvolved for a proper answer. You may want to go to a car parts store, and get arepair manual for your car.They cost about $16.00Or, go to a Public Library.
First plan on about 1 hour to change the belts, you will need a tire wrench, jack & jack stands or a ramp, 10 mm wrench, Phillips head screwdriver, 12 mm & 13 mm sockets.
Jack the car up on the passenger side, use a jack stand and block the rear wheels. Remove the passenger side front wheel, remove the inner shield (4 Phillips head screws), working from under the car loosen the tension wheel nut and adjusting bolt, this will allow you to remove the a/c belt.
Next workin on top, loosen the top & bottom bolts on the alternator, then loosen the adjustment bolt. It will take some work to remove the serpentine belt, there is tight fit between the rear most pully and the inner fender.
Reverse steps, it might be helpful to have a friend to thread the new belt on.
Begin by loosening the tensioner pulley on the front of your 1996 Nissan Maxima engine. Slide the tensioner pulley to the right. The old Power Steering belt will become loose and can be removed. Put the new power steering belt on. Tighten the power steering belt by sliding the tensioner pulley to the left.
What year is it? @004-2008 have timing chains
where is my power steering belt located
I am trying to change the Belt that goes around the power steering pump on my 2003 maxima and don't know how to release the tention from the belt. This is the inner belt I'm speaking of..Thanks for any assistance/direction
runs the power steering pump that makes it easy to turn
What have to do replace the belts water pump power steering
How do you replace power steering belt on 2003 Mazda protege ?1.6
Loosen the tensioner pulley. The power steering belt will come loose. Remove the power steering belt. Reverse the process to install the new power steering belt.
from underneath the car belt has to be tightened from underneath the car
To change a power steering belt on a Rover 214, unbolt the power steering pump and pry the belt off the pulley. Replace with another steering belt and reinstall the steering pump.
How do you change the power steering belt on a 1996 lexus es300?
Check the tension on the belt. A power steering pump will whine if there is too much belt tension, putting pressure on the side of the pulley.
Replace the power steering pump located just right of the windshield washer fluid reservior in the left front corner of the engine compartment. Add power steering fluid and replace serpentine belt. (Belt part #: 425K4)
The squealing could be that you need to add power steering fluid. Also you should check the belt that operates the power steering pump, if bad replace it. If the power steering pump is full and the belt is ok, then you may need to replace the power steering pump.