0
To change the brake pads on a 2002 Pontiac Aztek, start by lifting the vehicle and removing the wheel. Next, remove the caliper bolts and carefully slide the caliper off the rotor. Take out the old brake pads, replace them with new ones, and ensure the caliper piston is pushed back to accommodate the new pads. Finally, reassemble the caliper, secure the bolts, put the wheel back on, and lower the vehicle.
What else can I help you with?
Where is the abs fuse located on a 2002 Pontiac aztek?
fuse abs pontiac aztek 2002 located
The brake light wont go off on 2002 Pontiac aztek?
Might be a stuck brake light switch its located at the top of the brake pedal
How do you replace the thermostat on a 2002 Pontiac Aztek?
AnswerCould someone post directions on how to change the thermostat on a 2002 Pont. Aztek? Is it any different than a 2003?It shouldn't be any different....
Is there a fuel shut off switch on a Pontiac aztek?
Where is the fuel shut off on 2002 aztek
Which brake fluid should i use for a 2002 Pontiac aztek?
More than likely DOT3 but to make sure look on the top of the master cylinder cap. It is always written there.
How do you change the brake master cylinder on a 2002 Pontiac Montana?
how to change the master cylinder without taking it to a shop
Where is anti-lock sensor on 2002 Pontiac aztek?
The anti-lock brake sensors on a 2002 Pontiac Aztek are typically located at each wheel, mounted on the wheel hub or near the brake rotor. These sensors are part of the anti-lock braking system (ABS) and are responsible for monitoring the speed of each wheel. If you're looking to inspect or replace them, you'll need to lift the vehicle and remove the wheel to access the sensors. Always consult the vehicle's service manual for precise locations and procedures.
How many quarts of oil does a 2002 Pontiac Aztec hold?
The Aztek holds 5 qts of oil
Where is oil filter located on 2002 Pontiac aztek?
On a 2002 Pontiac Aztek, the oil filter is located on the engine, typically near the oil pan. It is mounted on the side of the engine block, making it accessible from under the vehicle. You may need to remove some components or use a wrench to reach it easily. Always ensure the engine is cool before attempting to change the oil filter.
How do you a change a battery in a 2002 Pontiac Montana?
how do you change a battery on a 2002 Pontiac Montana
Change front brake pads on a 2002 Nissan Sentra?
How do you change brake pads on a 2002 Nissan Sentra? How do you change brake pads on a 2002 Nissan Sentra? How do you change brake pads on a 2002 Nissan Sentra?
How do you change ignition lock on 2002 Pontiac aztek?
To change the ignition lock on a 2002 Pontiac Aztek, start by disconnecting the negative battery cable for safety. Remove the steering column covers and then access the ignition switch by unscrewing it from the column. Use a key to turn the ignition to the "Accessory" position, which will allow you to press the release tab and remove the old lock cylinder. Finally, insert the new ignition lock cylinder, reassemble the steering column covers, and reconnect the battery.
