Want this question answered?
To change the dash light bulbs you must remove the instrument panel.
What model of Corolla ? You have to take the dash board out and the bulbs can be removed and replaced from the back. The dashboard on the Corolla is not that difficult to take out, but you have to do it slowly and carefully.
Headlight bulbs, high and low beam, parking light bulbs, signal light bulbs, brake light bulbs, dash light bulbs, interior light bulbs, plate light bulbs, etc.
It is practically impossible to reach up behind the dash to change the bulbs. Remove the trim around the instrument panal and you should be able to pull it out enough to change the bulbs. You may have to disconnect the speedometer to get it out far enough.
you need to pull the dash apart and take the cluster out and the bulbs just twist out
You have to remove the instrument cluster to get access to the bulbs.
To change the gauge lights on a 1998 Ford Taurus SE, the dash cover has to be removed to access the burned out bulbs. There are screws and clips holding the dash cover on.
easy
There are several bulbs for dash illumination. They are attached to the backside of the dash cluster. The best way to access the bulbs would be to remove the dash cluster.
This requires you to pull the dash panel out - the bulbs are located behind that. You will need to remove the trim pieces around the dash - then the dash display itself. Good luck. Eric
Right behind dash board
To change the light bulb for the heater control on the 2006 Tahoe, you will either need to replace the entire climate control panel or remove and re-solder the bulbs. You can remove the bulbs by first removing the dashboard bezel and then the dash itself. Access the bulbs and pull them out of the control panel. Solder new bulbs into the panel.?æ