Remove the screw that holds the trim piece in place the pull that out. then you can either remove the whole cluster or leave it in. I would just leave it in. Remove the plastic cover, there should be four clips holding it on. then remove the needles from the gauges make sure to remember where your fuel one is to. then remove the screws that hold the panels on and pull them out, then pull the old bulbs out, you may need to use a pair of needle nose pillars then put the new bulb in and put everything back on but turn your car on before putting the clear plastic back on to make sure your gauges are accurate.
Underneath the steering column
Mounted on top and inside the fuel tank.
In my Toyota tercel model 1998 is located in right part of the engine, next to the windshield. Right beside the brake fluid canister. I hope that helps.
The 1998 Toyota signal relay switch is located below the dashboard, on the drivers side. The signal switch simply plugs in and out.
It does not have a fuel pump cutoff switch.
There is no carburetor on a 1998 tercel, it's fuel injection. Just go get a can of sea foam mootor tune up in a can and pour into your fuel tank. and that should clean your fuel injector nozels.
the gap should be: 0.044" (according to http://www.ngksparkplugs.com/part_finder/index.asp)
The 1998 Toyota ignition coil is located on the firewall, in the engine compartment. The ignition coil can be found on the passenger side of the firewall.
How do you change a timing belt on a 1998 Toyota Tacoma? And what part do I need to buy?
change the bulb out for the brake light and that fixes the problem.
how to removed charcoal canister for toyota camry 1998 6cyc
The warning lights on the dash of a 1998 Toyota Rav4 can mean anything from low fuel to brake problems or overheating. Each light has a unique image which denotes the specific problem.