you need a rivet tool and a new 1/4 inch rivets for this job. support window halfway down. remove door trim panel. drill out the for hold down pins ont the regulator. remove the rear guide channel. disconnect electrical connector. slide regulator off the guides and out the acess hole. replace new regulator. slide onto channels and rivet to door. plug in the electric connector. replace rear slide channel. install door trim.
what about it?
They are the small electric motors that raise and lower automobile windows in vehicles with electric window controls.
I need instructions on how to change the window motor in 1995 Chevy Camaro.
Besides the motor it may be the electric wires going to the switch is broken or a bad fuse.
you can change the window moter for a new one. so no
There are magnets found in most electric motors which are throughout your car eg electric window motors. They are also in your alternator. I assume that they are also used in the needles on your dashboard too.
Take it to a dealer. You will have to drill and replace rivets and the spring power of the lift mechanism can cause injury and problems. This is not a job for an amateur mechanic.
In order to replace the electric window motors on a Pontiac Grand Prix you will need to unscrew the Torx screws on the door, life it back to remove the plastic pieces. Remove all connectors, and the plastic covers.
check the following; fuses, relays, regulator, window motor, off track, window switch. did not specify if it was manual or electric.
The nearside electric window winder doesn't work Are both motors served by the same fuse?
Show me you how to install window motor for 1992 Chevy camaro
Yes