Yes it takes a 36mm wrench and a holder for the pulley to remove the fan clutch,
First you will have to take the motor out and separate the Transmission from the motor, then you have to take the clutch off of the flywheel and put the new one on with an alignment tool, then you put it all back together.
This is a BIG job and beyond the back yard mechanic's knowhow and special tool inventory. Take it to a garage.
Unbolt the engine lift it up and turn it to the side where u see the tranny, unbolt the transmission, unbolt the pressure plate from the flywheel, take the clutch out, when u put a new one in make sure to use a clutch allingment tool
You need a special tool to remove and replace the clutch. Your local auto parts store can sell or maybe rent you the tool.
Use the clutch spreader tool in the tool box to spread the secondary clutch once the secondary clutch is open the old belt should be able to pop right out, then install the new belt unscrew the tool roll the track a few times and the new belt is installed
u need a fan clutch tool or a strap wrench to hold the pulley and a wrench take off the nut
To remove the clutch fan on a 1993 Mercury grand marquis hold the fan in place using a clutch fan tool, then remove the holding nut. Most large auto parts chains will loan you the tool.
Using a special clutch fan tool to hold the fan still, remove the fan nut and take the fan off of the dodge 360. The tool should be available for rental from a local auto parts.
follow these steps 1. take out battery 2. take out fan your gonna need the room 3. take out starter 4 take out transmission 5 use the ailgnment tool that comes with the new clutch. 6 take out clutch with alignment tool and then 7 replace pilot bearing you are gonna have to take out the fly to do this 8. replace fly wheel with new pilot bearing and insert new clutch and pressure plate 9 on the inside of transmission housing there is a clutch release bearing u have to change that after that 10 reserve order steps 1-4 i just got through doing mines any questionemail me rscott12@yahoo.com
Purchase a clutch rebuild kit, and a clutch puller tool.
there is a tool called a "clutch removal tool" that can be purchased from j c whitney.,
You need a clutch puller tool(Special tool)! As well as good luck, Some are very difficult to impossible.