when you open up your hood and look down between the radiator and your front bumper you can see the fog lamp housing. Youll also notice two bolts on top, remove those two bolts and then pull the housing toward the center of the car to free them from the mount, pull the housing as far toward you as you can and then remove the rubber cover, pull the wire attached to the bulb(the one that plugs into the cars wire) out or pull both wires out to get a better view of what youre doing, although i don't recommend the latter as the housing's terminal has a weak pin and too much play could probably break. pop the latch covering the bulb and then remove the bulb. If youre looking to replace the entire lamp housing then just remove the stock ones and replace them in the same place (may require modification).
i need motor of Isuzu axiom 2002
How do you put on a serpentine belt on a 2002 Isuzu axiom
5 Qt with filter change and 4.2 without
take out light bulb in a dash
inside the gas tank
Had the same problem with my 2003 Axiom... It was my intake gasket. 50 dollar gasket.... easy fix
Under the intake manifold, under the upper outlet.
On the very low rear of the engine block. It is difficult to get to.
under the passenger side.... behind glove box
I heard someone comment that it has a "sealed" transmission, therefore, a dealer has to add fluid. I own a 2002 Isuzu axiom. they don't have a dipstick but they do have a holding tank on the right side you check and add fluid there.
Its a so called maintanence free trans. I had to get my trans replaced at 68k.
There is no dipstick for the trans.