i have a 1994 Chevy beretta and they are under the engine
Freeze (Expansion) plugs are located in the Engine cooling system. There is no specific location where they must be. They can be installed in the block, cylinder heads, and often in both locations.
you have to remove the motor and it still a painfull time consuming job
According to one of Ford's websites : For a 1991 LTD Crown Victoria , 5.0 liter / 302 cubic inch V8 : ( .050 inch spark plug gap )
Yes, it will fit.
yes as long as you put it on right
There is a large bolt on the bottom of the crankcase, underneath the brake.....that is your drain plug.
Some have a nut in the center,U take off the nut,etc-Others U take out like a Regular freeze-plug00just knock it in & B sure 2 REMOVE ALL the Pieces.A g00d time 2 flush out,from the freeze plug hole.IF U don't go in2 Freezing weather I would install a BRASS Plug & U won't have 2 worry about that one.IF U kept the cooling system clean & 50/50 CORRECT TYPE anyi-freeze U wouldn't have welch(freeze) plug problems.
It has 8 all together.
Approximately 302 Cubic Inches.
098
.040"