Usualy the torque difference fom the 305 to the 350 will cause a hard shift problem but check with the aftermarket computer chip co. but yes this can be swapped over. also be sure to switch all of the sensors etc so the change over is identical...
The engine computer uses the solenoid pack in the transmission to change which clutches get hydraulic pressure to control what gear is applied.The engine computer uses the solenoid pack in the transmission to change which clutches get hydraulic pressure to control what gear is applied.
engine oil and the transmission oil
the transmission is located on the driver's side of the engine and yes the engine has to be removed to change the transmission
engine oil and the transmission oil
To change an automatic galant to a 5-speed, you need a Computer for the Manual transmission of that year, and an engine.
Problem with the transmission. You need to have the transmission computer checked for codes to know a possible cause.
I you pulled a P0700 out of the engine computer it means that you need to check the transmission computer (tcm) for codes also.I you pulled a P0700 out of the engine computer it means that you need to check the transmission computer (tcm) for codes also.
P0700 is set in the engine computer when the transmission computer has also set codes. You need to know the codes in the transmission computer to know possible causes and cost.P0700 is set in the engine computer when the transmission computer has also set codes. You need to know the codes in the transmission computer to know possible causes and cost.
The 626 has a PCM which controls both the engine and the transmission.
Depends if you have a manual or automatic. Manual transmission, no, there is no transmission computer. For an automatic transmission, the engine computer and transmission computer are one unit typically called an ECM, Engine control module. There are many different names for and ECM. Ford started using computer controlled transmissions in the early 90's and late 80's.
On a Chrysler vehicle the engine computer sets P0700 whenever the transmission computer has detected and set a fault. You will need to have transmission codes checked to know possible causes.On a Chrysler vehicle the engine computer sets P0700 whenever the transmission computer has detected and set a fault. You will need to have transmission codes checked to know possible causes.
the transmission is made together into the engine casing in most atvs. yours is no different. to change the transmission, you must change the complete engine assembley. if you are having problems with the transmission and it needs repair. you must tare down the complete engine and rebuild it.